Mounting the bearing sleeves

In order to be able to fill the bearing sleeves with resin (from the top), I first had to put the rudder in a vertical position. It’s a bit of a beast but I managed to do it on my own without dropping it.

The next picture shows the (top) bearing sleeve completely filled with resin. If I ever have to remove the sleeves I’m in a lot of trouble ….

I also worked on the bottom side of the new carbon tiller.

This is how it all worked out. Note that I mounted the tiller the wrong way round!

Bonus picture of the ventilators after putting some epoxy paint (left over from painting the rudder) on them.

Geef een reactie

Het e-mailadres wordt niet gepubliceerd. Vereiste velden zijn gemarkeerd met *